Sas - Xtool H6EB User Manual

Enter the Enter maintenance mode menu and release the
3.
handbrake brake. And press OK after completing the instructions
shown.
Wait until the message of 'Successful operation' popes up. And
4.
press OK to exit the menu.
Enter the Exit maintenance mode menu and wait until the
5.
message of ''Successful operation' popes up.

5.3 SAS

Steering Angle Sensors (SAS) System Calibration permanently stores
the current steering wheel position as the straight-ahead position in the
SAS EEPROM. Therefore, the front wheels and the steering wheel
must be set exactly to the straight-ahead position before calibration. In
addition, the VIN is also read from the instrument cluster and stored
permanently in the SAS EEPROM. On successful completion of
calibration, the SAS fault codes will be automatically cleared.
To reset the steering angle, you need to first find the relative zero point
position for the car to drive in a straight line. Taking this position as a
Figure 5-4 Sample of EPB function (screen 1)
Figure 5-5 Sample of EPB function (screen 2)
39