Throttle; Sas - Xtool IP608 User Manual

Wait until the message of 'Successful operation' popes up. And press OK to exit the menu.
4.
Enter the Exit maintenance mode menu and wait until the message of ''Successful operation' popes up.
5.

THROTTLE

Throttle Position Sensor (TPS) Match, this function enables you to make initial settings to throttle actuators and returns the
"learned" values stored on ECU to the default state. Doing so can accurately control the actions of regulating throttle (or idle
engine) to adjust the amount of air intake.
The operation guidelines of the Throttle function are shown as below:
1. Enter the Throttle menu and choose relevant models according to the vehicle being tested.
2. Enter the Auto Recognition menu and turn on the ignition switch.
3. Read carefully and complete the requisites listed before performing the throttle regeneration function. And press OK
after completing the instructions shown.
4. Wait until all the parameters are read and displayed.
Press F2 button and wait until a message of 'Match successfully' popes up.
5.

SAS

Steering Angle Sensors (SAS) System Calibration permanently stores the current steering wheel position as the straight-
ahead position in the SAS EEPROM. Therefore, the front wheels and the steering wheel must be set exactly to the straight-
21