Fault; Figure 4-14: Webeasy - Fault Part 1 - evertz 5782ENC-H264HD-IPASI User Manual

4.9.

FAULT

5782ENC-H264HD-IPASI has a Fault Page where the following information can have traps set and will
display if there is a fault present. Where red indicated there is a fault present and green indicates there
is no fault present.
For each of the 10 SNMP Trap Destinations the following parameters are available:
Destination Enable: This parameter allows the user enable this Destination to be able to send a
Trap to. This parameter is reserved for future use. For current trap destinations please configure the
Destination IP address on the 570FC.
Destination IP Address: This parameter allows the user to enter the IP address to associate with
this destination. This parameter is reserved for future use. For trap current destinations please
configure the Destination IP address on the 570FC.
Memory Self Test Send Trap
Memory Self Test: This control sends out a trap if there is a fault generated by the memory self test.
Memory Self Test Fault Present
Memory self test: This monitor displays the fault condition of the memory self test. Green indicates
healthy while red indicates a fault.
SFP External Link Send Trap
SFP (1 or 2) External Link: This control sends out a trap if there is a fault generated on the SFP
external Links.
Professional Contribution H.264 and MPEG-2 Encoder
Figure 4-14: WebEASY
Revision 1.0
5782ENC-H264HD-IPASI
– Fault Part 1
®
Page - 23