Figure 5-2: Illustration Of Bnc Outputs 1 And 2 - evertz 5782ENC-H264HD-IPASI User Manual

Data Port Monitor
For Data Port Monitor 1 and Data Port Monitor 2
SFP Part Number: This parameter returns the part number of the SFP located in the Data Port.
Link Status: This parameter returns the link status for the Data Port. The status could be either Up or
Down.
Link Info: When the link is Up, this parameter returns link speed & duplex mode information for the
Data Port.
Receive Bandwidth: When the link is Up, this parameter returns the receive bandwidth currently
being read on the Data Port. Reading is in kbps.
Transmit Bandwidth: When the link is Up, this parameter returns the transmit bandwidth currently
being sent on the Data Port. Reading is kbps.
Output Port Mux Select
BNC 2 Output (OUT 1) and BNC 4 Output (OUT 2): This parameter allows the user to select the
BNC output type. Options are:
•
Contribution encoder ASI
•
V-Proc (video processor) HD/SD-SDI Loopout
(HD/SDI-Loopout will forward the currently selected input).
Encoder Control
Encoder SDI Input: 5782ENC-H264HD-IPASI has two HD/SD SDI input interfaces. One input is
used for the main feed and the other input for backup. This parameter is used to select the SDI input
for all encoders.
Syslog Configuration:
Syslog is a valuable tool for debugging 5782ENC-H264HD-IPASI operation. It is essentially serial
readouts over IP, sent to a dedicated server. If issues are present Evertz can help install and setup a
syslog server for constant monitoring of 5782ENC-H264HD-IPASI activity.
External Syslog: This parameter allows the user to enable or disable sending syslog information to
the configured external server.
Syslog Server IP: This parameter allows the user to assign the external syslog server IP address.
This will be the address of a PC with the syslog server software installed (ex Kiwi Syslog Server).
Temperature

Figure 5-2: Illustration of BNC Outputs 1 and 2

Revision 1.0
5782ENC-H264HD-IPASI
Professional Contribution H.264 and MPEG-2 Encoder
Page - 29