evertz 5782ENC-H264HD-IPASI User Manual page 24

Prefessional contribution h.264 and mpeg-2 encoder
Table of Contents

Advertisement

5782ENC-H264HD-IPASI
Professional Contribution H.264 and MPEG-2 Encoder
Total TS Bit Rate: This parameter allows the user to select the output TS Bitrate in kbps. The device
will automatically adjust the bitrate for video based on audio and advanced PID configuration to
maintain the set TS bitrate.
TS Encapsulation Type: This parameter allows the user to select the output encapsulation type. The
options are UDP or RTP.
Audio Delay: This control allows for the user to add audio delay. Range is 0 to 200 ms.
Encoder Enable: This parameter allows the user to enable or disable streaming out of the device.
This will stop the IP output and the ASI output when disabled.
Encoder Type: This parameter allows the user to set the encoder type. Options are MPEG 2 or
H264.
Pixel Depth: This parameter allows the user to set the pixel depth. Options include:
MPEG 2
4:2:2 8-bit
4:2:0 8-bit
H264
4:2:2 10-bit
4:2:2 8-bit
4:2:0 8 bit
Backup Output Stream State: This parameter enables or disables Data 2 (SFP 2) to be used for
backup.
Backup IP Address (Data 2): This parameter allows the user to select a streaming output IP
address for the Contribution Backup Encoder. Can be a Multicast or Unicast address.
Backup UDP Port Number (SFP 2): This parameter allows the user to select the destination UDP
port number of the backup streaming output.
Encoder Controls Basic
PMT PID (16 to 8190): This parameter allows the user to select the PMT PID number of the output
stream.
Video PID (16 to 8190): This parameter allows the user to select the Video PID number of the output
stream.
Encoder Controls Tables
Digital Television Standard: This parameter allows the user to select the DTV tables to use.
Options are ATSC, MPEG and DVB.
When set to DVB, options for settings are:
Program Name: This parameter allows the user to enter the DVB program name.
Provider Name: This parameter allows the user to enter the DVB provider name.
Service Type: This parameter allows the user to set the DVB service type. Options include
Digital TV, Digital Radio, Teletext, NVOD Reference, NVOD Timeshifted, Mosaic, PAL Signal,
SECAM Signal, DMAC, FM Radio, NTSC Signal or Data Broadcast.
Page - 14
Revision 1.0

Advertisement

Table of Contents
loading

Table of Contents