Table of Contents
Advertisement
4.7.
FAULT CONTROL
The fault control tab is a user configurable tab for enabling or disabling the fault conditions that can be
triggered by the standard ETSI TR 101 290 checks discussed in the previous chapter.
The four window sub-sections allows users to custom configure which ETSI TR 101 290 test conditions
can trigger an alarm:
Within this tab it is possible to individually de-select (all are selected by default) or later re-select which
tests can produce an alarm condition. The following subsections correspond with the previous Syntax
Error tabs:
•
P1 Necessary for Decoding
•
P2 Recommended
•
P3 DVB Tables
•
P3 ATSC Tables
It is important to ensure new settings are applied using the apply button on the menu.
Note: DVB/ATSC P3 tests may be greyed out depending on which mode has been
selected under the Input Monitor Tab (DVB/ATSC or MPEG). ATSC mode will disable
DVB; DVB mode will disable ATSC and MPEG will disable both ATSC and DVB.
7880DEC-MP2HD-2 Dual HD MPEG-2 Decoder
Figure 4-6 VistaLINK
®
Revision 1.0
7800 MultiFrame Manual
PRO Fault Monitor
7880DEC-MP2HD-2 - 31
Advertisement
Table of Contents
