Hardware Installation; 3.3.1. Three Different Ways To Control And Configure The 5782Enc-H264Hd-Ipasi; 3.3.2. Module Installation; Figure 3-2: 570Fr Chassis - evertz 5782ENC-H264HD-IPASI User Manual

5782ENC-H264HD-IPASI
Professional Contribution H.264 and MPEG-2 Encoder
3.3.

HARDWARE INSTALLATION

3.3.1. Three Different Ways to Control and Configure the 5782ENC-H264HD-IPASI

There are two different ways that 5782ENC can be controlled and configured:
1. WebEASY using the 570FC frame controller with 5782ENC-H264HD-IPASI installed in frame.
®
2. VistaLINK using the 570FC frame controller with 5782ENC-H264HD-IPASI installed in frame.
®

3.3.2. Module Installation

Before handling the card it is important to minimize the potential effects of static electricity. It is
therefore recommended that an ESD strap be worn.
Locate on the 570FR frame chassis one adjacent vacant slot. Unpack the 5782ENC-H264-HD-IPASI
and separate the rear plate module from the main card. Locate on the rear of the rack the one slot and
remove the blanking panel. Insert the rear plate module into the back of the chassis and secure using
the two screws provided.
Insert the 5782ENC-H264HD-IPASI card into the corresponding front slots ensuring the card lines up
with the slot runners on the bottom and the top of the chassis. Push the card into the slot ensuring that
when it mates with the rear card that is has been firmly pushed into a seated position. Use the thumb
screw to properly secure the module. Do not over tighten thumb screws.
Page - 6

Figure 3-2: 570FR Chassis

Revision 1.0