Table of Contents
Advertisement
SQVEx 05.2
SQVEx 14.2/ SQRVEx 05.2
ACVExC 01.2 Non-Intrusive Modbus RTU
Backlight
7.3.1.
Menu layout and navigation
Groups
ID
Group selection
Direct display via ID
SQRVEx 14.2 Control unit: electronic (MWG)
Push buttons
Navigation sup-
port on display
[4] C
Setup
Esc
The display is illuminated in white during normal operation. It is illuminated in
red in case of a fault.
The screen illumination is brighter when operating a push button. If no push
button is operated for 60 seconds, the display will become dim again.
The indications on the display are divided into 3 groups:
Figure 45: Groups
[1]
Start menu
[2]
Status menu
[3]
Main menu
Status menu and main menu are marked with an ID.
Figure 46: Marking with ID
S
ID starts with
S
= status menu
M
ID starts with
M
= main menu
It is possible to select between status menu S and main menu M:
For this, set selector switch to 0 (OFF), hold down push button C for approx. 2
seconds until a screen containing the ID M... appears.
Figure 47: Select menu groups
You return to the status menu if:
the push buttons on the local controls have not been operated within 10 minutes
or by briefly pressing C
When entering the ID within the main menu, screens can be displayed directly (without
clicking through).
Functions
Enter Main menu
Cancel process
Return to previous display
Operation
45
Advertisement
Table of Contents
