Table of Contents
Advertisement
ProCore Edge North America
Single-Cable Connection
Start, for a single-cable connection, by disconnecting the end of
the cable from the termination block located at the very bottom of
the charger. Then, unplug the communications, starting from
the bottom power module, until the module to be replaced has
been disconnected. (Figure 28)
NOTE
The ribbon cable has a red edging to denote Pin 1.
Always, when facing the module, insert the connectors
so that the cable red line is on the left.
31241-03-01
Figure 28 Single-Cable Connection
Page 46 of 68
Webasto Charging Systems, Inc.
IOMM
Advertisement
Table of Contents
