Table of Contents
Advertisement
IOMM
Installation Precautions
DANGER
Only authorized, trained, and qualified personnel
should install and service this charger.
Installation must be carried out only by suitably qualified personnel
and in accordance with the NEC, ANSI/NFPA 70, or equivalent,
and comply with current local and national wiring regulations.
DANGER
NEVER PLACE THE CHARGER DIRECTLY ABOVE
OR BELOW THE BATTERY BEING CHARGED.
Gases or fluids from the battery will corrode and damage
the charger.
Locate the charger as far away from the battery as
•
DC cables permit.
WARNING
The charger is only for indoor use.
Do not expose the charger to rain.
•
The charger should be sited in a cool, dry, and well-ventilated
location away from corrosive fumes and humid atmospheres.
An ambient temperature range of between −4°F and 113°F must
be maintained.
Ensure that ventilation is not obstructed at the left air-intake
•
and right exhaust vents.
Check, before installation, that the charger has not sustained any
damage in transit. Make sure that the electrical ratings are
suitable for both the intended AC input supply and the DC output
current and voltage for the batteries to be charged. Also, ensure
that the screw terminal connector polarity is correct and matches
the battery connector polarity.
Webasto Charging Systems, Inc.
ProCore Edge North America
Page 9 of 68
31241-03-01
Advertisement
Table of Contents
