Sony DNW-A100 Maintenance Manual page 338

5-22. Brake Lining Replacement
2. Brake Assembly Removal
(1) Remove the spring put on the RS table block
assembly.
(2) Remove the E ring, then remove the brake
assembly.
3. Brake Lining Removal
Remove the spring put on the brake arm block,
then remove the brake lining.
Installation
4. Brake Lining Installation
(1) Combine a new brake lining and brake arm
block as shown in the figure.
(2) Hook the spring on the brake arm block.
5. Brake Assembly Installation
(1) Pass the brake assembly through the shaft of
the RS table block assembly.
(2) Hook the spring on the RS table block
assembly.
(3) Install the brake assembly with a new E ring.
6. Reel Table Assembly Installation
(1) Clean the circumference of the reel table
assembly.
(2) Push the reel brake in the direction indicated
by the arrow to make free, and pass the reel
table assembly through the reel motor shaft.
n
Tighten two set screws of the reel table
assembly after the reel table height confirma-
tion is complated.
5-154
* The T reel break is replaced by the same way of the S one.
E ring
Spring Brake assembly
Brake lining
Spring
Brake arm block
Brake Lining Removal/Installation
S reel table assembly
S reel brake
S reel motor shaft
Reel Table Assembly Installation
RS table block
assembly
T reel table assembly
Cleaning
T reel brake
T reel motor shaft
DNW-A100/A50/A45
DNW-A100P/A50P/A45P