Sony DNW-A100 Maintenance Manual page 231

3. Remove the RS Table Block Assembly
(1) While pulling out the slide shaft, remove the
RS table block assembly.
(2) Disconnect the flat cable from the connector
on the RM board.
(3) Wipe the grease that is adhering to the holes
(two) pulled out the slide shaft on the RS
table block assembly using a cloth.
(4) Wipe the grease that is adhering on the
surface of the slide shaft using a cloth.
m
. Be careful not to adhere grease smeared the
slide shaft to another parts.
. Be careful not to cause damage to the slide
shaft during removal.
4. Disconnect the Harnesses
Disconnect the harnesses from the two connectors
CN926 and CN927 on the RM board.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
5-9-1. Replacement Procedure of the Reel Motor Assembly
RS table block assembly
RM board
Remove the RS Table Block Assembly
Connector (CN927)
RM board
Disconnect the Harnesses
Slide shaft
Flat cable
Connector (CN926)
5-47