Sony DNW-A100 Maintenance Manual page 233

Installation
6. Cleaning
Clean the mounting surfaces of the reel motor
assembly and reel motor plate.
7. Attach the Reel Motor Assembly
(1) Pass the reel motor assembly through the hole
of the reel motor plate as in the direction
shown in the figure.
(2) Tighten the three screws gradually while
moving the reel motor assembly in the
direction indicated by the arrow A.
Tightening torque: 68.6 x 10
{7 kgf . cm}
(3) Pass the poly-slider washer removed in (2) of
step 5 through the reel motor shaft.
8. Connect the Harnesses
Connect the harnesses to the two connectors
CN926 and CN927 on the RM board.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
< S side >
_2 N . m
Connector (CN927)
RM board
< T side >
Reel motor assembly
5-9-1. Replacement Procedure of the Reel Motor Assembly
Screws (PSW3 x 10)
Reel motor plate
Connector (CN926)
Reel motor plate
Cleaning
(Bottom surface)
Spacers
Cleaning
Hole
A
Connector (CN927)
Attach the Reel Motor Assembly
Cleaning
(Bottom surface)
Spacers
Cleaning
Hole
Reel motor
assembly
A
Screws (PSW3 x 10)
Connector (CN926)
RM board
5-49