Sony DNW-A100 Maintenance Manual page 311

Removal
1. Remove the Bottom Plate
(1) Place the unit on its right side panel down.
(2) Remove the six screws and remove the
bottom plate.
2. Remove the Hard Disk Drive Unit
Remove the hard disk drive unit.
(Refer to Section 5-31-2.)
3. Remove the DR-315 Board
(1) Strech the harness clamper and release the
harness.
(2) Remove the two screws shown in the figure.
(3) Move the DR-315 board toward the reel
motors about 1 cm, and detach the hook.
n
The hook is hard to be seen since it is the
inner part.
(4) Pull out the DR-315 board as far as possible
with connectors are connected state.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
5-19. Gear Box Assembly and Threading Motor Replacement
Screws (B4 x 6)
Screws (B4 x 6)
Bottom plate
Screws (B4 x 6)
Remove the Bottom Plate
Screw
(PWH3 x 8)
Screw
(PWH3 x 8)
Remove the DR-315 Board
Hook
Harness
Harness
clamper
DR-315 board
5-127