Sony DNW-A100 Maintenance Manual page 309

Adjustment
7. Loosen the Screw
Loosen the fixing screw of the adjustment plate
by 1/4 to 1/2 turn.
8. Slant Guide Slantness Adjustment
(1) Insert a 3 mm flatbladed screwdriver into the
notch of the adjustment plate.
(2) Adjust the position of the adjustment plate so
that specification 3 is satisfied.
. When the tape touches with the upper flange:
Move the adjustment plate in the direction
indicated by arrow A.
. When the tape touches with the lower flange:
Move the adjustment plate in the direction
indicated by arrow B.
9. Tighten the Screw
Tighten the screw loosened in step 7.
10. Tape Running Reconfirmation at TG-
10 Guide
(1) Put the unit into the unthreading end mode.
(2) Put the unit into the PLAY mode again, and
reconfirm that the tape runs at the TG-10
guide with specification 3 is satisfied state.
If specification 3 is not satisfied, repeat steps
7 through 10.
11. Apply Locking Compound
Apply the locking compound to the fixing screw
of the adjustment plate.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
5-18-2. Slant Guide Slantness Adjustment
Adjustment plate
Fixing screw (PSW3 x 8)
(Apply locking compound)
Slant Guide Slantness Adjustment
A
B
Notch
TG-10
5-125