Sony DNW-A100 Maintenance Manual page 320

5-20. Threading Ring and Ring Roller Replacement
6. S Plate Assembly Removal
(1) Remove the bundling band and disconnect
the harness from the connector CN200 on the
TC-96 board.
(2) Remove the bundling band and disconnect
the harness from the connectors on the CTL
head board, full-erase head board and tape
end sensor board.
(3) Unhook each harness (CTL head, cleaning
roller and tape end sensor) from the sensor
holder.
n
Never unhook the harness for full-erase head
from the sensor holder.
(4) Remove the screw, then remove the S plate
assembly.
c
The tape cleaner has a sharp edge. Pay
careful attention when handling the tape
cleaner.
5-136
Harness
Harness
(Full-erase head)
(Tape end sensor)
Sensor holder
Screw
(PWH3 x 8)
S plate
assembly
TC-96 board
S Plate Assembly Removal
Harness
(Clerning roller)
Bundling band
Harness
(CTL head)
Tape cleaner
Tape end sensor
CN200
Full-erase head
CTL head
DNW-A100/A50/A45
DNW-A100P/A50P/A45P