Sony DNW-A100 Maintenance Manual page 127

3. Check the setting on the upper control panel.
REMOTE/LOCAL 8 LOCAL (unlit 9P)
4. Check the settings on the sub control panel.
OUT REF switch
PROCESS CONTROL switch
. VIDEO switch
. CHROMA switch
. SET UP or BLACK LEVEL switch 8 PRESET
. Y/C DELAY switch
. CHROMA PHASE switch
KEY INHIBIT switch
5. Check the setup extend menu settings.
(NTSC model only)
ITEM-709: CAV LEVEL FORMAT
1. OUTPUT CAV LEVEL
ITEM-713: VIDEO SETUP REFERENCE LEVEL
0. MASTER LEVEL
3. BETACAM PB LEVEL
4. OUTPUT LEVEL
6. Connect the equipment.
(Refer to Figure "Connection".)
7. Check that the equipment has warmed up.
Before starting the adjustment, warm up the VTR and
other equipment through the power for 20 minutes or
more.
8. Stop the extending of the board.
Do not use the extension board in this adjustment.
n
Before removing board, wait for more than 30 seconds
after turning off the POWER switch.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
1. METAL Y/C Check
1. During play back the alignment tape in PLAY mode,
check the white level of Y signal.
8 REF
If the specification is not satisfied, adjust it.
8 LOCAL
PB portion:
8 PRESET
8 PRESET
Adj. point:
Specification: NTSC: A = 714 ± 7 mV (100 ± 1 IRE)
8 PRESET
8 PRESET
NTSC model
8 OFF
A
8 B-CAM
8 0.0%
8 MSTER
2. During play back the alignment tape in PLAY mode,
8 MSTER
check the levels of R-Y and B-Y signals.
If the specification is not satisfied, adjust so that both
levels of R-Y and B-Y signals satisfy the specification.
PB portion:
Adj. point:
Specification: B = 700 ± 7 mV
R-Y
B
3. Eject the alignment tape.
RV201
RV201
RV101 and RV201 on TBC-24 Board
3-8. Analog Betacam PB System Alignment
3-8-18. Component Output Level Adjustment
Color-bar signal (14:00 to 17:00) of
CR5-1B (NTSC) / CR5-1B PS (PAL)
1RV101/TBC-24(F-1)
A = 700 ± 7 mV
PAL:
PAL model
A
The same as step 1
1RV201/TBC-24(A/B-1)
B-Y
B
TBC-24 board (suffix-11 and 12)
RV200 RV500 RV501 RV300 RV101
TBC-24 board (suffix-13 and higher)
RV101
RV500 RV501 RV504 RV300
3-91