Automatic Shutdown - Tele Radio TG-T9-1 Installation Instructions Manual

NOTE! If the transmitter already have receivers registered, we recommend that you erase all receivers
from the transmitter before starting the replacement. The receiver will automatically be stored in the
same position as it was stored in the old transmitter. If this position is not available, the replacement will
not take place.
Replace a transmitter with a new transmitter
1. Make sure that the stop button is pressed.
2. Twist and pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release the right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
6. Press button 3.
7. Enter the serial number/ ID code for the transmitter that you want to replace by pressing the buttons
according to the table below:
TG-TX-MNL8, TG-TX-MNR8:
DIGITS
BUTTON TO PRESS
1 1
2 2
3 3
4 4
5 5
6 6
7 the right start button + 1
8 the right start button + 2
9 the right start button + 3
0 the right start button + 4
8. Press the left start button.
When completed successfully, the top LED lights green. If not completed successfully within 25
seconds, the top LED lights red and the transmitter turns off.
AUTOMATIC SHUTDOWN
Turning on automatic shutdown can save battery capacity by automatically turning the transmitter off
when no function has been activated for a set time.
Set the time for automatic shutdown
1. Make sure that the stop button is pressed.
2. Twist and pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
TG-TX-MXL12, TG-TX-MXR12:
BUTTON TO PRESS
1
2
3
4
5
6
7
8
9
10
- 46 -