Register - Tele Radio TG-T9-1 Installation Instructions Manual

When completed successfully, the top LED lights green. If not completed successfully within 25 seconds,
the top LED lights red and the transmitter turns off.

REGISTER

WARNING! Do not perform this when the receiver is in a session with another transmitter. The radio
communication may become disturbed or broken.
NOTE! Before starting to perform these settings, make sure that the stop relays are deactivated!
Register the transmitter in the receiver
1. Select [Register Tx] from the receiver display menu. Select [Yes] to start registering. The receiver will
stay in registering mode for 1 minute or until a transmitter has been registered.
2. On the transmitter: Make sure that the stop button is pressed.
3. Twist and pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
4. Press the right start button. Keep pressed.
5. Press the stop button.
6. Release the right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
7. Press button 1 to enter registering mode on the transmitter.
8. Select an empty slot by pressing any button on the transmitter, except the start buttons. If a slot is
occupied, the corresponding LED lights red. When you have selected an available slot, the
corresponding LED flashes.
9. Press the left start button.
10. When the receiver has found the transmitter, confirm by pressing the receiver joystick.
11. The transmitter is now registered in the receiver. The transmitter turns off..
- 44 -