Login/Logout - Tele Radio TG-T9-1 Installation Instructions Manual

LOGIN/LOGOUT

NOTE! If you need to log out a transmitter that is lost or damaged, it is possible to log out from the
receiver. We do not recommend this way of logging out. Contact your representative for assistance.
NOTE! To be able to control a receiver, the transmitter must be registered in the receiver, and logged
in to the receiver. If another transmitter is already logged in to the receiver, it has to be logged out
before any other transmitter can be logged in. If no transmitter is logged in to a receiver, a registered
transmitter will automatically log in when sending radio signals to the receiver. The transmitter will stay
logged in until it is manually logged out. More than one transmitter can be registered in the receiver, but
only one transmitter can be logged in at a time.
Quick logout
NOTE! When the transmitter has established radio communication with one or more receivers, you
can make a Quick logout from those receivers. Note that the Quick logout will log the transmitter out
from all receivers that are participating in the session.
1. Make sure that the transmitter is started in operating mode.
NOTE! The transmitter must have established a radio session with one or more receivers.
2. Press the left start button. Keep pressed.
3. Press the stop button.
4. Release the left start button.
The top LED lights red.
The transmitter turns off after logging out.
Logout from menu mode
1. Make sure that the stop button is pressed.
2. Twist and pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release the right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
6. Press the left start button.
7. To select what receiver to log out from, press:
TG-TX-MNL8, TG-TX-MNR8: button 1-6
TG-TX-MXL12, TG-TX-MXR12: button 1-10
The corresponding LED lights.
8. Press the left start button.
- 43 -