Frequencies & Channels - Tele Radio TG-T9-1 Installation Instructions Manual

3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release the right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
6. Press button 5.
7. Press a button according to the table.
Press...
Left start button
Button 1
Button 2
Button 3
FREQUENCIES & CHANNELS
NOTE! If your system is transmitting on the frequency bands 433MHz eller 2.4 GHz, the receiver will
automatically detect and switch to the same channel that the transmitter is using. If your system is
transmitting the 915 MHz frequency band, you have to switch bank in the receiver by using the PC
program Settings manager. Contact your representative for assistance.
Switch channel on the transmitter
1. Make sure that the stop button is pressed.
2. Twist and pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release the right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
6. Press the right start button. Keep pressed.
7. Press button 4. NOTE! Release button 4 before releasing the right start button.
8. Go to the frequency table and select a channel.
9. Enter a new channel with the buttons according to the table. The LED next to the left start button
lights when a digit has been entered. If the channel that you have selected contains only one digit, press
the left start button directly after entering the first digit.
Results in...
auto shutdown off
auto shutdown after 2 minutes
auto shutdown after 6 minutes
auto shutdown after 12 minutes
- 47 -