Automatic Shutdown - Tele Radio Tiger T2 Installation Instructions Manual

8.Press the left start button.
The display shows [Replacing] while the process is ongoing.
If the replacement fails, the display shows [FAILED].The transmitter turns off.
If the replacement succeeds, the display shows [OK]. The transmitter turns off.

AUTOMATIC SHUTDOWN

Turning on automatic shutdown can save battery capacity by automatically turning the transmitter off
when no function has been activated for a set time.
Set the time for automatic shutdown
1. Start the transmitter.
2. Enter menu mode.
3. Go to [Auto Shutdown]. Select by pressing the left start button.
4. Select the time that you want for automatic shutdown: 0-255 minutes. If you want to turn off
automatic shutdown, select 0. Confirm by pressing the left start button.
FREQUENCIES & CHANNELS
NOTE! The receiver will automatically detect and switch to the same channel that the transmitter is
using.
Switch channel on the transmitter
1. Make sure that the stop button is pressed.
2. Pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release the right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
6. Go to [Channel/Bank].
7. Go to the frequency table and select a channel. Confirm by pressing the left start button.
- 26 -