Installing The Mud Ring Bracket - Extron electronics CSVEQ 100 D User Manual

4. Mount the line driver to the wall box with machine screws
as shown in the following illustration.
Wall opening
is flush with
edge of box.
Mounting the line driver to a wall box
Attach the Decora
5.
the illustration above.
6. Reconnect the power supply, connect input cables to the
line driver, and restore power to the equipment.

Installing the mud ring bracket

The CSVEQ 100 D can also be installed using the included mud
ring bracket. See the illustration below.
1. Once the proper wall location for mounting the line driver
has been determined, cut an opening in the wall using the
proper mounting template found in the appendix.
2. Carefully cut away the mounting surface material inside
the traced template lines
3. Test the fit of the mud ring. The doglegs should fit easily
into the hole and the flat portion should rest flush against
the wall. See the note in the following illustration.
4. Rotate all doglegs inward.
Wall Box
wall plate to the line driver as shown in
®
Extron
CSVEQ 100 D
O
I D E
S - V
I N
I N
E O
V I D
IN
D IO
R
A U
L
Decora
Faceplate
CSVEQ 100 D • Installation 2-5