Access Control (Zk) - SimonsVoss Digital Cylinder AX Manual

Digital Cylinder AX (Z5)

6.3.2 Access Control (ZK)

(Manual)
For all closures in which the tappet position of the Digital Cylinder AX

affects the function of the lock, the Digital Cylinder AX AP (anti-panic
cylinder) may have to be used; this must be specified in the lock
manufacturer's approval.
DANGER
Due to the structural properties of panic locks, it is not permitted to turn the
knob of the Digital Cylinder AX to the stop, as this can affect the lock's
panic function.
CAUTION
Use of the anti-panic version of the locking cylinder in non-approved
locks
If you use the anti-panic version of the locking cylinder in unauthorised
locks, the escape door function may be impaired and cannot be released
again.
1. Only use the anti-panic version of the locking cylinder in locks for which
the locking cylinder is expressly approved.
2. Please refer to the documentation of the respective lock manufacturer.
3. Contact SimonsVoss Technologies GmbH for further information on this
Help and other information [
subject (see
This option equips the Digital Cylinder AX with additional functions:
Access event logging

The Digital Cylinder AX stores the most recent accesses with date, time
and transponder ID (TID). Up to 3000 accesses are saved and then the
oldest accesses are overwritten. You can read out the data with a
programming device or via the network.
Time zone control

You can limit the access authorisation of identification media on a time-
controlled basis. Within the different time zone plans at G2 100 (+1),
time zone groups for each area are available for this purpose (e.g. 1st
floor).
You can set the time zones of the time zone management for an entire
week or for each day individually.
Even without power supply, the Digital Cylinder AX maintains its status,
programming and stored protocols permanently.
6. Basic configuration, profiles and fea-
157]
).
}
tures
21 / 158