Information And Warning Messages; Led Indicator Lamps On The Charging Station - Husqvarna CEORA Razor 43M Operator's Manual

6.3 Information and warning messages

The information messages in the table below are shown in the
Speak to your Husqvarna representative if the same message shows frequently.
Message
Cutting system imbalance
Connectivity problem
Wrong PIN code
GPS navigation problem
Connection NOT changed
Ultrasonic problem

6.4 LED indicator lamps on the charging station

For a fully functional installation, the indicator lamps in the charging station must show a solid or flashing green light. If
another color shows, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, speak to your local Husqvarna representative.
Light
Green solid light
Green flashing light
Red flashing light
Red solid light
42 - Troubleshooting
Cause
The product senses vibrations in the cut-
ting disc.
®
Problem with the Automower
module.
An incorrect PIN code was entered. 5
tries are permitted, and the product is
then blocked for a period of time.
Temporary electronic or firmware related
problem in the product.
The signal of the charging station was
not changed.
The product is not connected to the
charging station.
The ultrasonic sensor is dirty or blocked.
Temporary electronic or firmware related
problem in the product.
Status
Good signals.
ECO mode is activated. Refer to ECO mode on page 24 .
The signals are good and
Interruption in the charging station's antenna. Speak to your local Husqvarna repre-
sentative.
Fault in the circuit board or incorrect power supply in the charging station. The fault
must be correct by an authorized service technician. Speak to your local Husqvarna
representative.
Messages menu in the Automower
Action
Examine the blades and screws for dam-
ages and wear. Make sure that all blades
are correctly installed and that there is
only one blade attached in each position
on the blade disc.
Connect Restart the product. If the connection
problem stays, disconnect the product
from Automower
pairing operation. If the problem stays,
speak to your local Husqvarna represen-
tative.
Enter the correct PIN code. If the PIN
code is incorrect, use the web address in
the app to send the PIN code to your reg-
istered e-mail address. If you have not
registered the e-mail address, speak to
your local Husqvarna representative.
Restart the product. If the problem stays,
speak to your approved servicing dealer.
Make a new charging station signal a
number of times. If the problem stays,
speak to your authorized service center.
Do a pairing operation between the prod-
uct and the charging station. If the prob-
lem stays, speak to your authorized serv-
ice center.
Clean the ultrasonic sensor.
Restart the product. If the problem stays,
speak to your approved servicing dealer.
®
Connect app.
®
Connect and do a new
1691 - 002 - 14.01.2022