Information And Warning Messages; Led Indicator Lamp On The Charging Station - Husqvarna Automower 550 EPOS Operator's Manual

6.3 Information and warning messages

The information messages in the table below are shown in the
Speak to your Husqvarna representative if the same message shows frequently.
Message
Cutting system imbalance
Connectivity problems
Wrong PIN code
Ultrasonic problem
GPS navigation problem

6.4 LED indicator lamp on the charging station

For a fully functional installation, the indicator lamp in the charging station must show a solid or flashing green light. If
another color shows, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, speak to your local Husqvarna representative.
Light
Green solid light
Green flashing light
Red flashing light
Red solid light
34 - Troubleshooting
Cause
The product senses vibrations in the
blade disc.
®
Problem with the Automower
module.
An incorrect PIN code has been entered.
5 tries are permitted, and the product is
then blocked for a period of time.
Temporary electronic or firmware related
problem in the product.
Status
Good signals.
ECO mode is activated. Refer to ECO mode on page 21 .
The signals are good and
Interruption in the charging station's antenna. Speak to your local Husqvarna repre-
sentative.
Fault in the circuit board or incorrect power supply in the charging station. The fault
must be correct by an authorized service technician. Speak to your local Husqvarna
representative.
Messages menu in the Automower
Action
Examine the blades and screws for dam-
ages and wear. Make sure that all blades
are correctly installed and that there is
only one blade attached in each position
on the blade disc.
Connect Restart the product. If the connection
problem stays, disconnect the product
from Automower
pairing operation. If the problem stays,
speak to your local Husqvarna represen-
tative.
Enter the correct PIN code. If the PIN
code is incorrect, use the link in the app
to send the PIN code to your registered
e-mail address. If you have not regis-
tered the e-mail address, speak to your
local Husqvarna representative.
Restart the product. If the problem stays,
speak to your approved servicing dealer.
®
Connect app.
®
Connect and do a new
1576 - 004 - 16.11.2021