Husqvarna CEORA Razor 43M Operator's Manual page 25

Alarm duration
There is a possibility to set how long the alarm signal
should last. A setting between 1 and 10 minutes is
possible.
STOP button pressed
"STOP button pressed" is enabled, the
If the alarm
alarm goes off if someone presses the STOP button and
the PIN code is not entered within 30 seconds.
Carried away
Carried away is enabled, the product senses
If the alarm
unexpected motions, and the alarm goes off.
3.8.7.4 GeoFence
GeoFence is a GPS-based theft protection that makes a
virtual fence for the product. If the product is more than
a set distance away from the center position the product
will be deactivated and an alarm will start. The center
position will be set to the current position of the product
when the function is enabled. The PIN code is needed to
deactivate the alarm and to start the product again. The
GeoFence is only enabled when the product is switched
on.
®
3.8.8 Automower Connect (Bluetooth
only)
®
Automower Connect you can enable or disable the
In
Automower ® Connect module. You can also see the
signal strength, connectivity status, initiate new pairing
or remove the product from the paired accounts.
3.8.9 Messages
In this menu the previous fault and information
messages can be found. For some of the messages,
there are tips and advice to help to rectify the fault.
If the product is disrupted in any way, for example it
is trapped or the battery is low, a message is saved
relating to the disruption and the time it happened.
If the same message is repeated several times, this
may indicate that an adjustment to the installation or the
product is required. Refer to Installation on page 13 .
3.8.10 Mowing profiles
You can save different sets of settings in the
profiles . Use this function when you use one product for
more than one location or to have different settings on
Mowing profiles the product
the same location. In the
settings, map objects and their settings are saved.
3.8.11 Download firmware over the air
(Firmware over the air FOTA)
The product has a function that automatically downloads
new firmware. When a new firmware is available, a
1691 - 002 - 14.01.2022
notification shows in the app where you can select
to install the new firmware. In the factory setting this
function is enabled.
®
Mowing
Installation - 25