Information Messages - Husqvarna AUTOMOWER 550 Operator's Manual

6.3 Information messages

The list below shows a number of information messages that may be found in the
Connect app. Contact your local Husqvarna representative if the same message appears often.
Message Cause
Low battery
The product cannot find the charging station.
The battery is spent.
The charging station's antenna is defective.
Settings restored
Confirmation that a
has been carried out.
Limited cutting height The cutting height adjustment cannot move.
Unexpected cutting
height adj
Limited cutting height
range
Cutting height prob-
lem
Cutting height
blocked
Cutting system imbal- The product has discovered vibrations in the
ance
blade disc.
Slope too steep The product stopped because the slope is
too steep.
Guide 1 not found
The guide wire is not connected to the charg-
ing station.
Guide 2 not found
Guide 3 not found
Break in the guide wire.
The guide wire is not connected to the boun-
dary loop.
40 - Troubleshooting
Action
Change the position of the guide wire. Refer
to
page 18 .
Make sure that the installation settings about
how to find the charging station is correct.
Refer to
Replace the battery. Refer to
page 34 .
Check if the indicator lamp in the charging
station flashes red. Refer to
lamp on the charging station on page 42 .
This problem requires action by authorized
service technician.
Reset all user settings
This is normal. No action required.
Examine the cutting height adjustment and
remove grass or other objects. If the problem
stays, speak to your approved servicing deal-
er.
Verify that the blades and screws are intact
and not worn out. Verify that all blades are
correctly mounted. Check that no double
blades are mounted on any of the three
blade positions.
Change the installation of the boundary wire
to not include this steep part of the work
area. Refer to
page 20 .
Check that the guide wire's connector is
tightly connected to the charging station. Re-
fer to
Find out where the break is. Replace the
damaged section of the guide wire with a
new loop wire and splice using an original
coupler.
Check that the guide wire is connected cor-
rectly to the boundary loop. Refer to
stall the guide wire on page 21 .
Messages menu in the Automower
To examine where to put the guide wire on
Battery on page 34 .
Battery on
LED indicator
To install the boundary wire on
To install the guide wire on page 21 .
1439 - 007 - 07.01.2021
®
To in-