Husqvarna CEORA Razor 43M Operator's Manual page 40

Message
No accurate position from
satellites
Reference station communi-
cation problem
Unexpected cutting height adj The cutting height adjustment cannot
Limited cutting height range
Cutting height problem
Cutting height blocked
Cutting deck not in correct
position
Destination not reachable
Too many waypoints
40 - Troubleshooting
Cause
Weak satellite signal to the reference sta-
tion.
Weak satellite signal to the product.
There is no radio signal between the
product and the reference station.
The reference station is not installed cor-
rectly.
The product does not receive the radio
signal from the reference station in all of
the work area.
Power failure.
There is an error in the reference station
and the LED indicator flashes red.
move.
The cutting deck is not attached correct-
ly.
The cutting deck is in service position.
There is no transport path between the
charging station and the work area or
maintenance point.
The transport path is blocked and the
product cannot go to the work area,
charging station or maintenance point.
There are too many waypoints in the cur-
rent work area.
Action
Examine the installation of the reference
station. Refer to the Operator's manual
for the Reference station.
Examine if there is an object between
the product and the sky that cause inter-
ference with the satellite signal. Remove
the object or do a new installation to not
include these parts in the work area. Re-
To make a work area on page 21
fer to
Do a pairing operation between the prod-
uct and the reference station.
Examine the installation of the reference
station. Refer to the Operator's manual
for the Reference station.
Examine if the product has radio signal
from the reference station in the full work
area. If not, make a new installation of
the reference station or a new installation
Installation of the
of the map. Refer to
map objects on page 20 .
Examine and correct the cause for the
power failure of the reference station.
Disconnect the power to the reference
station and connect it again to restart the
reference station. If the problem stays,
speak to your approved servicing dealer.
Examine the cutting height adjustment
and remove grass or other objects. If the
problem stays, speak to your approved
servicing dealer.
Make sure that the cutting deck is at-
tached correctly and that the lever is in
the correct position. If the problem stays,
speak to your authorized service center.
Make sure that the cutting deck is in cut
position. If the problem stays, speak to
your authorized service center.
Make a transport path between the
charging station and the work area or
maintenance point.
Make sure that the transport path is not
blocked, or delete the transport path and
make a new transport path.
Make a new the work area, stay-out
zone and transport path and use less
waypoints. Divide the current work area
into more work areas.
1691 - 002 - 14.01.2022