To Put The Cutting Deck In Service Position; To Put The Cutting Deck In Cut Position - Husqvarna CEORA Razor 43M Operator's Manual

Servicing
Examine and clean the airflow filter.
Replace the airflow filter.
Examine the charging cable and connector.
Charging station
Examine and polish the contact plates on the charging station.
Examine the mains cable, power supply unit, charging cable and connectors.
Open the charging station and replace the gasket.
Last step
Use a software service tool to do a function test of the functions of the product.
5.3 To put the cutting deck in service
position
1. Set the product to OFF. Refer to
to OFF on page 27 .
2. Open the hatch on the drive unit.
3. Tilt the lever.
1691 - 002 - 14.01.2022
4. Push down the lever and lift up the front of the
cutting deck by the handle. Make sure that the
cutting deck is in a vertical position.
To set the product
5.4 To put the cutting deck in cut
position
1. Use the front handle on the cutting deck to fold
down the cutting deck.
Every
Every
Weekly third
year
year
O
O
O
X
O
O
Weekly Every Every
year third
year
O
Maintenance - 31