Husqvarna CEORA Razor 43M Operator's Manual page 36

Message
No loop signal
Outside work area
36 - Troubleshooting
Cause
The mains cable is not connected.
The mains cable is damaged.
ECO mode is enabled and the LED in-
dicator of the charging station flashes
green. The product was started manually
in the work area but the STOP button
was not pushed before the product was
moved from the charging station. The
charging station signal is disabled and
the product cannot enter the charging
ECO mode on page 24 .
station. Refer to
The product does not find the loop signal
from the charging station.
The charging station in not installed cor-
rectly.
Interference from metal objects such as
fences, reinforcement steel or buried ca-
bles near the charging station.
The work area slopes too much by the
virtual boundary.
The transport path or the path to the
maintenance point slopes too much.
The product can not find the correct loop
signal because of interference with a
loop signal from a different product instal-
lation nearby.
Interference from metal objects such as
fences, reinforcement steel or buried ca-
bles near the charging station.
Action
If the LED indicator on the charging sta-
tion is out, it shows that there is no pow-
er. Examine the power outlet connection
and the residual-current device. Make
sure that the mains cable is connected
to the charging station.
Replace the mains cable.
Put the product in the charging station.
To start the
Start the product. Refer to
product on page 26 .
Put the product in the charging station
and make a new loop signal. Refer to
New loop signal on page 24 .
Install the charging station correctly. Re-
Installation of the charging station
fer to
on page 17 .
Change the position of the charging sta-
tion.
Make sure that the virtual boundary is
installed correctly. Refer to To examine
where to install the objects on the map
on page 15 .
Make sure that the transport path is in-
To examine
stalled correctly. Refer to
where to install the objects on the map
on page 15 .
Put the product in the charging station
and make a new loop signal. Refer to
New loop signal on page 24 .
Change the position of the charging sta-
tion.
1691 - 002 - 14.01.2022