Operation Mode Park; Operation Mode Park At Maintenance Point; To Stop The Product; To Set The Product To Off - Husqvarna CEORA Razor 43M Operator's Manual

4.6.1 To select operation mode Pause in
the app
1. Open the app on your mobile device.
2. Select Pause .

4.7 Operation mode Park

Park means that the product goes
The operation mode
back to the charging station. The product stays in the
charging station for a selected period of time or until you
select a new operation mode.
4.7.1 To select operation mode Park in the
app
1. Open the app on your mobile device.
Park .
2. Select
3. Select for how long the product must stay in the
charging station.
4.7.2 To select operation mode Park on the
control panel
1. Push the STOP button.
2. Push the Park button.
3. Push the START button.
The product stays in the charging station for 3 hours and
then it continues to operate to the set schedule.
4.8 Operation mode Park at
Maintenance point
You can park the product at the maintenance point to do
maintenance on the product.
4.8.1 To park the product at the
maintenance point with the app
1. Open the app on your mobile device.
Park > Maintenance point .
2. Select
The product is parked at the maintenance point until you
select a new operation mode.
4.8.2 To park the product at the
maintenance point with the control panel
1. Push the STOP button.
2. Push the Maintenance point button.
3. Push the START button.
The product is parked at the maintenance point until you
select a new operation mode.

4.9 To stop the product

1. Push the STOP button on top of the product.
The product stops and the cutting motor stops.
1691 - 002 - 14.01.2022
Note:
When you push the Play and START button
again, the product continues to operate in the same
operating mode as before.

4.10 To set the product to OFF

1. Push the STOP button on top of the product.
2. Connect the product with Bluetooth
the app.
Note:
The product cannot be set to OFF if it is
not connected to the app with Bluetooth
3. Push the ON/OFF button for 3 seconds to set the
product to OFF. Make sure that the LED indicator
goes out.

4.11 To charge the battery

WARNING:
safety instructions for the battery before you
use the product. Refer to
page 11 .
When the product is new or after long-term storage, the
battery can be empty. Charge the battery before you
start the product.
1. Push the ON/OFF button for 3 seconds to set the
product to ON.
2. Put the product into the charging station until the
charging plates touch the contact plates. Refer
to charging plates and contact plates in
overview charging station, CEORA
6 .
3. Make sure that the charging is in progress in
the Automower ® Connect app or that the LED
indicator pulsates blue.
Note:
If the charging does not start automatically,
disconnect and connect the mains cable to the charging
station to restart it. The charging starts automatically
when you restart it.
®
short-range in
®
.
Read and understand the
Battery safety on
Product
™ CS4 on page
Operation - 27