Table of Contents
Advertisement
•
Set the direction of the pattern.
•
Enable or disable the
Border mowing where the
product cuts around the work area 2-3 times along
the virtual boundary.
Border mowing . With Fixed
•
Set the type of the
border mowing the product always operates in
the same paths to keep a sharp border around
Variable border mowing , the
the work area. With
product operates in different paths to decrease the
risk of track marks along the virtual boundary.
3.8.4 Operation
Operation menu you can change the settings of
In the
Object avoidance and ECO mode .
the
3.8.4.1 Object avoidance
The
Object avoidance function makes the product
decrease speed when it comes near an obstacle to
avoid to collide with it.
Note:
This can cause that the grass is not cut around
the obstacle. This function can cause the product to not
cut high grass satisfactorily.
3.8.4.2 ECO mode
ECO mode is enabled, it switches off the signal in
If
the charging station, when the product is parked or is
charging.
Note:
ECO mode to save energy and prevent
Use
interference with other equipment, for example hearing
loops or garage doors.
Note:
To start the product manually in the work area,
push the STOP button before you remove the product
from the charging station. If not, the product cannot park
at the charging station.
3.8.5 Accessories
3.8.5.1 Headlights
There are 4 different headlight settings that control when
the headlights are on:
Always on
•
Evening only (19:00-00:00)
•
•
Evening and night (19:00-07:00)
24 - Installation
Always off
•
The headlight can be set to flash or to have a constant
light. The headlights can also be set to flash if there is
an error.
Note:
Husqvarna recommends to use the headlights
at night time.
3.8.6 General (Bluetooth
This function is used to set time and date, or to reset to
default settings.
3.8.6.1 Time & date
The time and date can be changed manually, or by
using the time and date from the mobile device.
3.8.6.2 Reset to factory settings
The user settings can be reset to factory settings. All
map objects and the schedules will be deleted.
Note:
PIN code, Loop signal, Messages and Date &
Time will not be reset.
3.8.7 Security (Bluetooth
The security settings controls the PIN code, the
GeoFence and other security functions. The correct PIN-
code must be entered to get access to the
®
menu in the Automower
Connect app.
3.8.7.1 New loop signal
The loop signal is randomly selected to create a unique
link between the product and the charging station. In
rare cases, there may be a need to generate a new
signal, for instance if 2 adjacent installations have a very
similar signal.
3.8.7.2 Change PIN code
You can change the PIN code in the Automower
Connect app. Make a note of the new PIN code in
Introduction on page 3 .
Memo. Refer to
3.8.7.3 Theft protection
Theft protection menu it is possible to set the
In the
alarm duration and also what events should trigger the
alarm. The factory setting is to require PIN code and the
alarm duration is 1 min.
®
only)
®
only)
Security
®
1691 - 002 - 14.01.2022
Advertisement
Table of Contents
