Husqvarna CEORA Razor 43M Operator's Manual page 37

Message
Empty battery
Slipped
Charging station blocked
Stuck in charging station
Upside down
Mower tilted
Lifted
Collision
1691 - 002 - 14.01.2022
Cause
The product cannot find the charging sta-
tion.
The battery is at the end of its life cycle.
The product cannot enter the charging
station because the antenna in the base-
plate of the charging station is defective.
The product hit an obstacle and stopped
or the wheels cannot move on the wet
grass.
The work area includes a steep slope.
The connection between the charging
plates on the product and the contact
plates on the charging station is not
good. The product made a number of
tries to charge.
An object prevents the product to enter
the charging station.
The charging station tilts or is bent.
The product cannot move out from the
charging station because it is blocked.
The baseplate has a wet or dirty surface
that prevents the product to move out
from the charging station.
The product tilts or the body of the prod-
uct is with the top down.
The product tilts more than the maximum
angle.
The lift sensor was enabled because the
product was lifted.
The body of the product cannot move
freely around its chassis.
The product cannot move forward or
rearward.
Action
The product has no accurate position
and cannot find the charging station.
There is an obstacle that prevents the
product to find the charging station.
Replace the battery. Refer to
page 33 .
If the LED indicator on the charging
station flashes red, the antenna of the
charging station is defective. Speak to
your authorized service center.
Move the product and correct the cause
of problem. If it is because of wet grass,
wait until the lawn is dry before you use
the product.
Maximum slope is 45%. Isolate steep
To install the map ob-
slopes. Refer to
jects in a slope on page 15 .
Put the product in the charging station
and make sure that the charging plates
and contact plates are connected.
Clean the contact plates on the charging
station and the charging plates on the
product.
Remove the object.
Put the baseplate on level ground.
Examine why the product cannot move
out from the charging station. Remove
objects and clean the baseplate of the
charging station.
Put the product in the correct position.
Move the product to an area that has lev-
el ground.
Make sure that the body of the product
can move freely around its chassis. Re-
move or make a stay-out zone around
objects that can cause the body of the
product to be lifted. If the problem stays,
speak to your authorized service center.
Remove dirt or object between the chas-
sis and the body of the product. Make
sure that the body of the product can
move freely around its chassis.
Remove the object that prevents the
product from operation.
Troubleshooting - 37
Battery on