Information And Warning Messages - Husqvarna AUTOMOWER 405X Operator's Manual

6.3 Information and warning messages

The information messages in the table below are shown in the display of the product. Speak to your Husqvarna
representative if the same message shows frequently.
Message Cause
Limited cutting height The cutting height adjustment cannot move.
Unexpected cutting
height adj
Limited cutting height
range
Cutting height prob-
lem
Cutting height
blocked
GPS navigation prob- Problem with the GPS assisted navigation
lem
equipment.
Weak GPS signal
The sky is blocked in large parts of the work
area.
Settings restored A Reset all user settings has been done.
Guide 1 not found The guide wire is not connected to the charg-
ing station.
Damage in the guide wire.
The guide wire is not connected to the boun-
dary loop.
Connection changed New loop signal changed.
Difficult finding home The product has been following the boundary
wire several laps without finding the charging
station.
Needs manual charg- The product is set to the
ing
erating mode.
1650 - 005 - 17.03.2022
Action
Examine the cutting height adjustment and
remove grass or other objects. If the problem
stays, speak to your approved servicing deal-
er.
Speak to your local Husqvarna representa-
tive if this message appears often.
Remove objects that can cause a blockage
of the GPS signal.
Disable the GPS navigation function and use
Lawn coverage function. Refer to GPS
the
Assisted Navigation, Lawn Coverage and
Systematic Passage Mowing on page 24 .
Usual operation of the product.
Connect the guide wire to the charging sta-
tion. Refer to
page 18 .
Replace the damaged section with new
guide wire.
Connect the guide wire correctly to the boun-
dary loop. Refer to
wire on page 18 .
Usual operation of the product.
The installation has not been done correctly.
Refer to
18 .
Wrong corridor width setting on boundary
wire. Refer to
page 18 .
The product was started on a Secondary
area with the Main area setting.
Secondary area op- Put the product in the charging station.
To install the guide wire on
To install the boundary
To install the boundary wire on page
To install the boundary wire on
Troubleshooting - 41