Replacing The Bulb - ElectrIQ eiQCURV60EN User Manual

REPLACING THE BULB

1. Switch off the extractor
hood and ensure it is
also switched off at the
mains supply.
2. Remove the grease
filters.
3. Disconnect the wiring
connector on the lead
running from the lamp
holder.
4. Replace the holder and
lamp with an identical
unit available from the
retailer/manufacturer.
NOTE: Remember to switch on at the mains once installation is
completed and the hood has been fully reassembled.
ILCOS D code for this lamp is:
DBS-2/65-H-120/33
• Max wattage: 1×2 W
• Voltage range: AC 110-240V
NOTE: The bulb must be replaced by the
manufacturer, its service agent or similarly qualified persons.
Always switch off the electricity supply before carrying out any
operations on the appliance. When handling the bulb, make sure it is
completely cool down before any direct contact to hands.
REPLACEMENT FILTERS
Replacement filters are available both from the retailer and directly
through the manufacturer.
eiQGFA60
eiQGFA90
14
eiQCF152
eiQCF15290