External Ventillation; Installation - ElectrIQ eiQCURV60EN User Manual

OPTIONS FOR VENTILATION
This hood can be set up for either external venting or recirculation of the
air. The type of setup should be decided before commencing

installation.

EXTERNAL VENTING
If you have an outlet leading outside, your
cooker hood can be connected as shown in the
diagram using a flexible exhaust pipe.
Alternatively, any suitable extraction duct
(enamel, aluminium, flexible pipe or
inflammable material with an interior diameter
of 120/150mm) can be used.
An adaptor is also supplied to enable you to
connect your hood to pre-existing 120mm
diameter ducting.
If this is the chosen installation method, consideration to the route of the
vent pipe should be made prior to installation.
NOTE: the performance of the hood may be affected if the diameter of
the pipe is reduced, or if the airflow is restricted.
RECIRCULATION
This cooker hood also supports the
recirculation of air once it has passed through
the filters. The filtered air is then expelled
through the vent holes in the side of the
chimney.
When setting the unit up in this configuration,
carbon filters should also be used to remove
odors from the air. Details of fitting the filters
can be found in the Carbon filter section.
When setting up for recirculation the installation instructions should be
followed, but the vent pipe should not be attached, allowing the air to be
expelled through the vents on the side of the chimney.
7