Bulb Replacement - ElectrIQ eiQSLIM100TOUCH User Manual

BULB REPLACEMENT

IMPORTANT: The light fitting must be replaced by the manufacturer, its
service agent or similarly qualified persons.
This hood is fitted with LED light units, which under normal operation can
last the lifetime of the hood. In the event that one does fail, replacement
light units are available from the same retailer the hood was purchased from.
Before changing the fitting, ensure the hood is turned off and the power is
removed by either unplugging the unit or switching off at the pole switch (if
installed) before attempting to change the bulb. Wait until the bulbs have
cooled down before commencing replacement.
1. Remove the grease filter.
2. Use a tool or the hand to press the spring splinter of both sides of LED
light to the inside, until the light is pressed out, see pic 1. Then slightly
pull the light connecting wire out, and dismantle the terminal of the light
connecting wire. See pic 2.
3. Apply the reverse procedure to install the light back.
Important
• If a bulb is found to be defective, it should be replaced immediately.
• Always switch off the electricity supply before carrying out any
operations on the appliance. When handling the bulb, make sure it has
completely cooled down before any direct contact to hands.
12