Advertisement
BULB REPLACEMENT
Before changing the bulb, ensure the hood is turned off and the power is
disconnected before attempting to change the bulb. Wait until the flitting has cooled
down before commencing replacement.
• Open the LED light plate assembly and take away the grease filter.See pic 1.
• Find the light wire at the back of the wire outlet.Then slightly pull the light connecting
wire out, and dismantle the terminal of the light connecting wire. See pic 2.
• Remove 4pcs screws on the hinge of light plate assembly,take out the light plate
assembly and pull out the light wire.If the light wire cannot be pulled out, it can be cut
directly with scissors.
• Apply the reverse procedure to install the light back.
ILCOS D code for this lamp is: DSS-1.5-S-70
MAX WATTAGE
VOLTAGE RANGE
DIMENSIONS
MAINTENANCE
Before cleaning, switch the unit off and pull out the plug, or switch off at the relevant
mains switch if the unit has been hard-wired in. Make sure the unit has no power being
fed to it.
REGULAR CLEANING
Use a soft cloth moistened with warm mildly soapy water or household cleaning
detergent. Never use metal pads, chemicals, abrasive material or a stiff brush to clean
the unit.
NOTE:
Do not use a steam-cleaner to clean the hood; electrical components could
be damaged or short-circuit as a result.
1.5 W
DC 12V
448×315MM
11
Advertisement
