Table of Contents
Advertisement
REPLACING THE BULB
This hood is fitted with an LED light unit, which under normal operation
can last the lifetime of the hood. In the event that it does fail,
replacement light units are available from the same retailer the hood was
purchased from.
Before changing the fitting, ensure the hood is turned off and the power is
removed by either unplugging the unit or switching off at the pole switch
(if installed) before attempting to change the bulb. Wait until the bulb has
cooled down before commencing replacement.
1.
Remove the glass canopy from the top of the
hood, following the Removal and refitting of
the glass canopy section.
2.
Locate the top of the light fitting and squeeze
the spring clips, while pushing the fitting out of the base of the hood.
5.
Replace with a new light unit, which after connecting the electrical
connection, should be pushed into position on the base of the hood.
6.
Refit the glass canopy.
Important
•
If a bulb is found to be defective, it should be replaced
immediately.
•
Always switch off the electricity supply before carrying out any
operations on the appliance. When handling the bulb, make sure it
has completely cooled down before any direct contact to hands.
3.
Follow the wire from the light unit
and find the power connector on the
lead.
4.
Disconnect the power connector
from it, ensuring the light fitting is not
allowed to fall from the unit
12
Advertisement
Table of Contents
