Bulb Replacement; Cleaning And Maintenance - ElectrIQ eiQ60PBSLIMEN User Manual

BULB REPLACEMENT

Before changing the bulb, ensure the hood is turned off and the power is disconnected before
attempting to change the bulb. Wait until the flitting has cooled down before commencing
replacement.
• Open the LED light plate assembly and take away the grease filter. See pic 1.
• Find the light wire at the back of the wire outlet. Then slightly pull the light connecting wire out, and
dismantle the terminal of the light connecting wire. See pic 2.
• Remove 4pcs screws on the hinge of light plate assembly, take out the light plate assembly and pull
out the light wire. If the light wire cannot be pulled out, it can be cut directly with scissors.
• Apply the reverse procedure to install the light back.
MAINTENANCE
Before cleaning, switch the unit off and pull out the plug, or switch off at the relevant mains switch if
the unit has been hard-wired in. Make sure the unit has no power being fed to it.
REGULAR CLEANING
Use a soft cloth moistened with warm mildly soapy water or household cleaning detergent. Never use
metal pads, chemicals, abrasive material or a stiff brush to clean the unit.
NOTE:
Do not use a steam-cleaner to clean the hood; electrical components could be damaged or
short-circuit as a result.