Exhaust Installation - ElectrIQ eiQCURV60EN User Manual

EXHAUST INSTALLATION

The following rules must be strictly followed to obtain optimal air
extraction:
• Keep the expansion pipe short and straight.
• Do not reduce the size or restrict expansion pipe.
• When using an expansion pipe always install the pipe pulled
taut to minimize pressure loss.
• Failure to observe these basic instructions will reduce the
performance and increase noise levels of the cooker hood.
• Any installation work must be carried out by a qualified
electrician or competent person.
• Do not connect the ducting system of the hood to any existing
ventilation system which is being used for any other appliance,
such as a warmer tube, gas tube or hot wind tube.
• The angle of the bend of the expansion pipe should be no less
than 120º; you must direct the pipe horizontally, or,
alternatively, the pipe should
go up from the initial point
and be led to an outer wall.
• After the installation, make
sure that the cooker hood is
level to avoid grease
collection at one end.
NOTE: Ensure the expansion pipe selected for installation
complies with relevant standards and is fire retardant.
11