Cover - Safety Vision ICOP PRO HD HVR User Manual

55

Cover

• Select the Cover option to enable cover alarms.
An alarm is triggered when it is detected that a
camera lens may have been covered or otherwise
obstructed.
• Alarm type: Select either Sensor (When a Sensor
alarm is triggered, it is recorded in video as metadata
only), or Event (When an Event alarm is triggered, it
marks recorded video as 'Alarm Video' with metadata
included).
• Trigger: Tap the Setup button to configure the
parameters specific to this type of alarm (see
Trigger Setup below)
• Linkage: Tap the Setup button to configure the
recording, monitor display and additional options
specific to this type of alarm (see Linkage Setup below)
Then tap the Save button.
Trigger Setup
Tap the Setup button under the Trigger field to display
the setup screen to configure the parameters specific to
the Cover Alarm.
• Channel: Select which channels the Cover alarm
will be applied to
• Sensitivity: Select either High, Middle, or Low
sensitivity
• Duration Time: Enter the time (between 0 and 255
seconds) that the alarm records
• Delay Time: Enter the time (between 0 and 255
seconds) that must occur when the camera lens is
covered or otherwise obstructed before triggering
the alarm
• Effective Time: Enter the time (between 0 and 10
seconds) that the alarm is effective (select the Question
Mark icon for more details)
Then tap the OK button.
Then tap the Save button.
ICOP PRO HD HVR USER GUIDE