Table of Contents
Advertisement
ICPMICKIT Microphone
Cradle
Installation
Use the following procedure to mount the
ICPMICKIT Microphone cradle:
1.
Secure the bracket to the rear of the cradle
with the four supplied Phillips-head screws
as shown.
2. Secure the cradle / bracket assembly to a
suitable location inside the vehicle with
six supplied Phillips-head screws or other
appropriate fasteners.
Note: Do not install the cradle in an area that
could interfere with the safe operation of the
vehicle.
3. Ensure the Power Switch on the microphone
is in the ON position.
4. Place microphone in base as shown.
The BATT status LED on the front of the cradle
displays red as the microphone charges. A full
charge from a new or depleted battery takes
approximately four (4) hours. When charging
is complete, the BATT status LED displays
green.
ICOP PRO HD HVR USER GUIDE
12
Advertisement
Table of Contents
