User Plate - Epson T-B Series Maintenance Manual

T3-B T6-B Maintenance 7. Covers

7.7 User Plate

■ Do not remove the user plate forcibly. Removing the user plate forcibly may result
in damage to the cables, disconnection, and/or contact failure.
■ When installing the user plate, be careful not to allow the cables to interfere with
the plate mounting and do not bend these cables forcibly to push them into the
cover. Unnecessary strain on cables may result in damage to the cables,
CAUTION
disconnection, and/or contact failure. When routing the cables, observe the cable
locations after removing the connector plate. Be sure to place the cables back to
their original locations.
T3-B
2-M4×10
User
(1) Remove the arm top cover.
Plate
Removal
(2) Cut off the wire tie binding the brake
(3) Unscrew the user plate mounting bolts and remove the plate.
User
(1) Put the user plate to the arm and secure using the mounting bolts.
Plate
Installation (2) Bind the internal cables with a wire tie as worked in the removal procedure (2).
(3) Mount the arm top cover.
NOTE

44
Reference 7.1 Arm Top Covers
cable and then remove the connector of
break release switch.
Reference 7.1 Arm Top Covers
For tightening hexagon socket head cap bolts, refer to "2.4 Tightening Hexagon Socket
Head Cap Bolts".
T6-B
2-M4×10
Joint #3
Motor
Brake
Cable
T-B series Maintenance Manual Rev.1
Joint #2
Motor