Epson T-B Series Maintenance Manual page 43

(8) Firmware and data file transfer starts. It takes several minutes to complete.
(9) The following dialog appears.
(10) The following dialog appears after the Controller reboot.
The firmware upgrade is completed.
Start EPSON RC+ 7.0 and restore the Controller settings.
For details of Controller Backup, refer to "5. Backup and Restore".
When you install the firmware (Ver.7.4.0.2 or later) on the controller which the firmware
NOTE

(before Ver.7.4.0.2) has been installed, the following message is displayed.
When the message is displayed, re-install the firmware.
T-B series Maintenance Manual Rev.1
Click the <Next> button to reboot the Manipulator.
Click the <Finish> button.
T3-B T6-B Maintenance 6. Firmware Update
31