Electric Installation - 2N IP Verso Installation Manual

2.3 Electric Installation

This subsection describes how to install the modules, how to connect the 2N
unit to the power supply and LAN and how to connect other elements.

Caution
• The device must be part of the electrical system of the building.
Mounting Preparation
1. Unscrew the second module cover on the main unit base.
2. Use a flat screwdriver to take out the module cover.
Version A – 2-Module Base
1. Place the base on the flush mounting box / predrilled holes with dowels and pull the
cables through the bottom holes. Pull the Ethernet cable including the connector through
the bottom hole to the left if necessary.
2. Insert the metal fitting elements up and down and screw the base plate tight. You can
level the base slightly if you are mounting just one base.
Version B – 3-Module Base
1. Unscrew the cover of the additional base.
2. Use a flat screwdriver to take out the cover.
3. Slide the additional base to the main unit base and secure its position with the small side
wedges and screws.
4. Remove the microphone from the main unit base and loosen the microphone cable.
5. Lead the microphone to the third module base as shown in the figure.
6. Place the joined bases on the flush mounting box / predrilled holes with dowels and pull
the cables through the bottom holes. Feed the Ethernet cable without the connector from
the additional base to the main unit base if necessary.
Version C – Additional Columns
1. Unscrew the cover of the additional bases and take it out with a flat screwdriver.
2. Insert the bases into each other as projected and secure their position with the small side
wedges and screws.
3. Place the cover on the flush mounting box / predrilled holes with dowels and pull the
cables if any through the bottom holes.
4. Pull the bus using the cable bushing available in the flush mounting box.
Installation manual 2N® IP Verso
®
IP Verso main
168 / 241