Install The Ultraglide Wiring; Install The Autoboom Node - Raven AutoBoom Installation Manual

For buhler versatile sx280

Hide thumbs Also See for AutoBoom:

Table of Contents

6. Insert the right wheel axle into the right wheel mounting bracket, positioning it so that the bottom of the wheel

touches the ground (or nearly so) and the wheel faces away from the machine.

7. Secure the gauge wheel assembly in the wheel mounting bracket by installing two 1/2"-13 x 1-1/2" SS hex bolts

(P/N 311-0058-186) and two 1/2" zinc hex nuts (P/N 312-1001-043).

8. Repeat the steps above to install the left wheel.

INSTALL THE ULTRAGLIDE WIRING

Wiring Connections

For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously on

both the male and female ends of the connectors. Application of the grease will prevent corrosion to the pins and

wires.

FIGURE 23. Node Mounting Location

1. Mount the AutoBoom node (P/N 063-0130-038) to the center rack using three 3/8"-16 zinc flanged lock nuts

(P/N 312-1001-164).

NOTE:

Position the node so that the cable connections point down.

2. Insert the large, rectangular node connectors on the harness cable (P/N 115-0230-095) into the correct ports of

the AutoBoom node.

3. Tighten the bolts on the node connectors to secure the connections.

P/N 016-0230-110 Rev. D

CAUTION

Always connect the power cable as the last step

in the wiring process and verify that the power

leads are connected with the correct polarity.

Reversing power leads can cause severe damage

to the equipment.

ULTRAGLIDE

Table of Contents