Install The Powerglide Plus Wiring - Raven AutoBoom Installation Manual

FIGURE 23. Gauge Wheel Installed
6. Insert the right wheel axle into the right wheel mounting bracket, positioning it so that the bottom of the wheel
touches the ground (or nearly so) and the wheel faces away from the machine.
7. Secure the gauge wheel assembly in the wheel mounting bracket by installing two 1/2"-13 x 1-1/2" SS hex bolts
(P/N 311-0058-186) and two 1/2" zinc hex nuts (P/N 312-1001-043).
8. Repeat the steps above to install the left wheel.

INSTALL THE POWERGLIDE PLUS WIRING

Wiring Connections
For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously on
both the male and female ends of the connectors. Application of the grease will prevent corrosion to the pins and
wires.
P/N 016-0230-110 Rev. D
CAUTION
Always connect the power cable as the last step
in the wiring process and verify that the power
leads are connected with the correct polarity.
Reversing power leads can cause severe damage
to the equipment.
POWERGLIDE PLUS
27