Yamaha MBK X-MAX 300 2017 Service Manual page 356

Fault code No. P0132
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
Probable cause of malfunc-
Item
tion and check
1 Installed condition of O
2 Connection of O
pler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
3 Connection of wire harness
ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
4 Wire harness continuity.
P0132
O sensor: power short circuit detected (no normal signals are re-
2
ceived from the O
Able to start engine
Able to drive vehicle
—
—
—
sensor. Check for looseness or pinch-
2
ing.
Improperly installed sensor →
Reinstall or replace the sensor.
Refer to "CYLINDER HEAD" on
page 5-13.
Improperly connected → Con-
sensor cou-
2
nect the coupler securely or re-
place the wire harness.
Improperly connected → Con-
nect the coupler securely or re-
place the wire harness.
Open or short circuit → Properly
connect or replace the wire har-
ness.
Between O
ECU coupler.
gray/red–gray/red
FUEL INJECTION SYSTEM
sensor).
2
Maintenance job
sensor coupler and
2
8-51
Confirmation of service com-
pletion
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recover" → Go to
item 7 and finish the service.
Condition is "Malfunction" → Go
to item 2.
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recover" → Go to
item 7 and finish the service.
Condition is "Malfunction" → Go
to item 3.
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recover" → Go to
item 7 and finish the service.
Condition is "Malfunction" → Go
to item 4.
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recover" → Go to
item 7 and finish the service.
Condition is "Malfunction" → Go
to item 5.